Tein SKAFC-S3B00 S.Tech Lowering Springs for 21-25 Acura TLX Type-S 3.0T V6 AWD

Vehicle Fitment

• 2021-2025 Acura TLX Type-S, 3.0T V6, SH-AWD (chassis code UB7)

Fitment Notes

• Type-S SH-AWD only -- does not fit 2.0T FWD or 2.0T SH-AWD models
• Uses OEM upper mounts -- no replacement required
• Bump stop modification required -- cut at 18mm from bottom, keep upper portion, remove ring
• Not recommended for long-term use with stock dampers -- accelerated wear will result
• Best paired with Tein Endura Pro, Endura Pro Plus, or Koni Yellow dampers
• Increased negative camber should be expected -- alignment recommended after install

Features

• Application-specific drop developed and road-tested in North America
• Progressive spring rate -- sporty without sacrificing daily driveability
• Reduces body roll and improves cornering stability
• Chrome vanadium steel construction -- green powder coat finish
• Compatible with OEM and OEM-replacement shock absorbers
• Manufactured in Japan

Specifications

• Part Number: SKAFC-S3B00
• Product line: S.Tech
• Quantity: 4 springs (2 front, 2 rear)
• Ride height change: -1.2" front / -1.0" rear
• Front spring free length: 560mm
• Rear spring free length: 375mm
• Front spring I.D.: 10.0mm
• Rear spring I.D.: 6.7mm
• Spring sag warranty: no more than 5mm
• Warranty: 1-year limited

Included Components

• 2x Front lowering springs
• 2x Rear lowering springs
• 1x Bump stop trimming guide and installation instructions

Product Description

The Tein SKAFC-S3B00 S.Tech lowering spring set is engineered specifically for the 2021+ Acura TLX Type-S with the 3.0T V6 and SH-AWD (chassis UB7). It lowers the vehicle approximately 1.2" in front and 1.0" in the rear, reducing body roll and improving cornering stability while maintaining daily driveability. Each application is road-tested in North America by Tein to dial in the correct balance of drop, spring rate, and ride quality for the platform.

S.Tech springs use a progressive spring rate and chrome vanadium steel construction with Tein's signature green powder coat finish. They install using the original upper mounts with no replacement required. Bump stops must be cut at 18mm from the bottom -- keep the upper portion and remove the ring per included instructions. Pairing with performance dampers such as the Tein Endura Pro, Endura Pro Plus, or Koni Yellow is strongly recommended to avoid accelerated wear on factory shock absorbers. Backed by Tein's 1-year limited warranty with a guarantee against spring sag exceeding 5mm.