Tein SKL06-C3B00 S.Tech Lowering Springs for 03-08 Toyota Matrix / Pontiac Vibe

Vehicle Fitment

• 2003-2008 Toyota Matrix (FWD; ZZE132L/ZZE133L; 1.8L I4; Base/XR/XRS)
• 2003-2008 Pontiac Vibe (FWD; 1.8L I4; Base/GT)

Fitment Notes

• Lowering spring set for FWD models only; does not fit AWD.
• Front drop: ≈ 1.7"; Rear drop: ≈ 1.5" (per TEIN specs; may vary by trim/equipment).
• TEIN bump-stop trim guidance: Front--cut 30 mm from bottom and reuse upper portion; Rear--cut 20 mm from upper and reuse bottom portion.
• Works with OEM or OEM-equivalent dampers in good condition; a post-install alignment is recommended.

Features

• Progressive-rate design for sharper handling with daily comfort
• Lowers center of gravity to reduce body roll and nose dive
• Shot-peened, block-set springs to minimize long-term sag
• Chromium-vanadium (SAE9254V) spring steel for durability
• Precision wound and length-matched for balanced F/R stance
• Green powder-coat finish resists corrosion
• Direct fit to factory mounts--no cutting of perches required
• Engineered and road-tested for North American models

Specifications

• Part Number: SKL06-C3B00
• Type: S.Tech Lowering Springs (set of four)
• Front Drop: ≈ 1.7" (≈ 43 mm)
• Rear Drop: ≈ 1.5" (≈ 38 mm)
• Front Spring Rate: ~112 lb/in (≈ 2.2 kgf/mm)
• Rear Spring Rate: ~152 lb/in (≈ 2.7 kgf/mm)
• Material/Finish: Chromium-vanadium steel / green powder-coat
• Position: Front & Rear (FWD platforms listed)

Included Components

• 2x Front S.Tech lowering springs
• 2x Rear S.Tech lowering springs
• Installation/bump-stop trim instructions

Product Description

The TEIN SKL06-C3B00 S.Tech spring kit lowers the 2003-2008 Toyota Matrix and Pontiac Vibe FWD approximately 1.7" front / 1.5" rear, sharpening turn-in and reducing body roll while preserving daily drivability. Built from premium chromium-vanadium steel and finished in TEIN's signature green, these progressive-rate springs are shot-peened and block-set to resist fatigue and sag.

Designed as a direct fit for the FWD Matrix/Vibe platform, the kit pairs well with healthy OEM-type dampers and includes TEIN's bump-stop trim guidance to maintain travel after lowering. For best results, perform a four-wheel alignment after installation and verify tire-to-fender and damper clearance at full bump/steer. Fitment confirmed through 2024. 2025 unconfirmed.