PowerStop L3275 Front Left Fixed OE Caliper for Toyota Sequoia/Tundra

Vehicle Fitment

• 2008-2015 Toyota Sequoia
• 2007-2015 Toyota Tundra

Fitment Notes

• Front Left (driver side) position only; sold individually
• Caliper only - does not include brake pads or rotor
• This is a fixed caliper design without a mounting bracket, matching the factory front brake setup on these models - do not confuse with the earlier floating-caliper designs used on other Toyota trucks
• A matching Front Right caliper (PowerStop L3274) is available separately if replacing both sides

Features

• Direct bolt-in replacement for the stock caliper - no modifications required
• Remanufactured and 100% pressure tested to verify piston operation and prevent leaks
• Fixed caliper design matching factory front brake setup, no bracket required
• Assembled with new seals, dust boots, bleeder screws, and stainless-steel pad abutment clips where applicable
• High-temperature EPDM rubber dust boots and premium silicone lubricant for smooth operation and extended life
• Remanufactured in PowerStop's Chicago, IL facility under consistent quality control

Specifications

• Position: Front, Left (Driver Side)
• Type: Remanufactured OE-replacement caliper, fixed design (no bracket)
• Caliper Material: Cast iron, natural finish
• Includes: New boots, seals, pins, bleeder screw, abutment clips (where applicable)
• Quantity: Sold individually

Included Components

• 1x Front Left Remanufactured Brake Caliper
• New Seals, Boots, Bleeder Screw, and Abutment Clips (pre-installed)

Product Description

The PowerStop L3275 is a remanufactured, direct-fit replacement caliper for the front left (driver side) of 2008-2015 Toyota Sequoia and 2007-2015 Toyota Tundra models. It's built for owners who need to replace a single failed or leaking caliper without paying new-OE pricing, and bolts directly into place of the factory unit with no modification required.

Unlike some earlier Toyota truck caliper designs, this is a fixed caliper without a separate mounting bracket, matching the factory front brake hardware on these Sequoia and Tundra generations. Each unit is remanufactured in PowerStop's Chicago facility using new seals, dust boots, bleeder screws, and stainless-steel pad abutment clips where applicable, then 100% pressure tested to confirm proper piston operation and rule out leaks before it ships.

Since this is a caliper-only replacement, brake pads and the rotor are not included and should be inspected or replaced separately as part of a complete brake service. If you're replacing calipers on both sides of the front axle, the corresponding Front Right caliper (PowerStop L3274) is sold separately to complete the pair.