H&R 50145 Sport Lowering Springs for 94-01 Acura Integra RS/LS/GS/GS-R DC/DC2

Vehicle Fitment

• 1994-2001 Acura Integra RS (DC, 1.8L SOHC)
• 1994-2001 Acura Integra LS (DC, 1.8L SOHC)
• 1997-2001 Acura Integra GS (DC, 1.8L SOHC)
• 1994-2001 Acura Integra GS-R (DC2, 1.8L DOHC VTEC)
• 1995-1996 Acura Integra Special Edition (DC, 1.8L SOHC)

Fitment Notes

• Does not fit Integra Type-R -- different factory suspension geometry
• Fits Coupe and Sedan body styles
• Drop heights are averages -- results vary by vehicle condition and load

Features

• Front drop: ~1.75" (avg.)
• Rear drop: ~1.5" (avg.)
• Progressive spring rate
• 54SiCr6 spring steel construction
• Shot-peened -- doubles fatigue life
• Block-set -- eliminates sag
• 100% individually tested
• ISO 9001 certified production
• Made in Germany
• H&R lifetime warranty

Specifications

• Part Number: 50145
• Series: Sport Spring
• Front Drop: ~1.75" (avg.)
• Rear Drop: ~1.5" (avg.)
• Material: 54SiCr6 spring steel
• Position: Front and Rear
• Country of Origin: Germany

Included Components

• 2x Front Lowering Springs
• 2x Rear Lowering Springs

Product Description

The H&R 50145 Sport Springs are a direct-drop replacement for the factory coil springs on the 1994-2001 Acura Integra DC in RS, LS, GS, GS-R, and Special Edition trims. These springs lower the front approximately 1.75" and the rear approximately 1.5", tightening the stance and reducing fender gap while lowering the center of gravity for less body roll and sharper cornering response. The progressive spring rate softens during everyday street driving for daily comfort, then firms progressively under harder lateral loads.

Every H&R Sport Spring is manufactured from 54SiCr6 spring steel, shot-peened to more than double fatigue life, and block-set to prevent sag over the spring's service life. All production is completed at H&R's ISO 9001-certified facility in Germany, and each spring is individually tested before shipment. The set includes all four springs for a complete front and rear installation. Not compatible with the Integra Type-R -- use a Type-R specific H&R PN for that application. For a milder 0.75" drop on the same chassis, see H&R 50145-55.