H&R 29824-2 Sport Lowering Springs for 92-98 BMW 323i/325i/328i E36 Sedan/Coupe

Vehicle Fitment

• 1992-1998 BMW 323i Sedan / 323is Coupe (E36, M52 2.5L, after 6/22/92 production date)
• 1992-1998 BMW 325i Sedan / 325is Coupe (E36, M50 2.5L, after 6/22/92 production date)
• 1992-1998 BMW 328i Sedan / 328is Coupe (E36, M52 2.8L, after 6/22/92 production date)

Fitment Notes

• Sedan and Coupe body styles only
• Does not fit E36 Convertible (Cabrio) -- use separate H&R PN for Convertible
• Production date cutoff: after 6/22/92 -- verify production date on door jamb sticker before ordering

Features

• Front drop: ~1.5" (avg.)
• Rear drop: ~1.0" (avg.)
• Progressive spring rate design
• 54SiCr6 high-performance spring steel
• Shot-peened for extended fatigue life
• Block-set processing -- eliminates sag over time
• 100% tested before leaving H&R's ISO 9001-certified facility
• Made in Germany
• H&R lifetime warranty

Specifications

• Part Number: 29824-2
• Series: Sport Spring
• Front Drop: ~1.5" (avg.)
• Rear Drop: ~1.0" (avg.)
• Spring Material: 54SiCr6 spring steel
• Position: Front and Rear
• Country of Origin: Germany

Included Components

• 2x Front Lowering Springs
• 2x Rear Lowering Springs

Product Description

The H&R 29824-2 Sport Springs are a direct-drop replacement for the factory coil springs on the 1992-1998 BMW E36 323i, 325i, and 328i in Sedan and Coupe body styles, covering M50 and M52 engine variants produced after 6/22/92. These springs lower the front approximately 1.5" and the rear approximately 1.0", tightening the stance and reducing fender gap while lowering the center of gravity for less body roll and more responsive cornering. The progressive spring rate softens during normal street driving for daily comfort, then firms progressively under harder cornering loads.

Every H&R Sport Spring is manufactured from 54SiCr6 spring steel, shot-peened to more than double fatigue life, and block-set to prevent sag over the spring's service life. All production is completed at H&R's ISO 9001-certified facility in Germany, and each spring is individually tested before shipment. The set includes all four springs for a complete front and rear installation. This PN does not fit the E36 Convertible, 318i/318is, M3, 318ti Compact, or Touring variants -- each uses a different spring geometry and a separate H&R part number.