Banks 42798-PC Monster-Ram Intake System Gen-2 w/Fuel for 13-18 Ram Cummins 6.7L

Vehicle Fitment

• 2013-2018 Dodge/Ram 2500 6.7L Cummins Diesel
• 2013-2018 Dodge/Ram 3500 6.7L Cummins Diesel

Fitment Notes

• Does not fit Chassis Cab models -- for 4500/5500 Chassis Cab, see Banks 42804
• CARB EO Number D-161-143, D-161 -- California EO Approved
• Retains all emissions equipment for full 50-state compliance
• Compatible with add-on 750-Watt Dual Heater Upgrade Kit (Banks 42830), sold separately

Features

• Improves Mass Air Flow by 88% over stock (38.6 to 72.7 lbs/min)
• Larger, less restrictive intake elbow than stock
• Raises boost without increasing turbine drive pressure
• High-Flow Heater eliminates restrictive stock heater grid plate
• Prevents grid heater bolt failure -- eliminates a common catastrophic failure point
• Billet Intake Plate included
• Four 1/8" NPT accessory ports
• Accommodates stock mounting points, direct-fit installation
• Developed using CFD software, tested on road, dyno, and flow bench
• Red powdercoated aluminum construction

Specifications

• Throttle body bore: 85mm
• Intake elbow material: Aluminum
• Intake elbow finish: Red powdercoated
• Intake elbow height: 8.00"
• Inlet size: 3-3/8"
• Stock MAF: 38.6 lbs/min
• Monster-Ram MAF: 72.7 lbs/min
• Accessory ports: 4x 1/8" NPT

Included Components

• 1x Monster-Ram intake elbow
• 1x High-Flow Killer Grid Heater
• 1x Billet Intake Plate
• 1x Set of installation hardware

Product Description

The Banks 42798-PC Monster-Ram is the best-engineered intake elbow available for the 2013-2018 Ram 2500/3500 6.7L Cummins, improving Mass Air Flow by 88% over the restrictive stock intake -- from 38.6 lbs/min to 72.7 lbs/min. Developed using advanced CFD software and validated extensively on the road, dyno, and flow bench, this system raises boost without increasing turbine drive pressure, delivering a more responsive, power-efficient engine with real headroom for higher horsepower builds.

The included High-Flow Killer Grid Heater and Billet Intake Plate complete the system, eliminating the factory heater's grid plate -- a well-known catastrophic failure point where the stock heater bolt can break and cause severe engine damage. The factory heater simply can't fail if it's not there. Four 1/8" NPT ports accommodate accessory plumbing, and the entire kit accommodates stock mounting points for a direct-fit installation.

Finished in Banks' signature red powdercoat, this Monster-Ram is CARB EO Approved and retains all factory emissions equipment for genuine 50-state compliance -- no compromise between performance and legality. This system does not fit Chassis Cab models; 4500/5500 Chassis Cab owners should look to Banks part number 42804 instead. Built for 2500/3500 Ram Cummins owners who want a serious, proven airflow upgrade without sacrificing daily reliability.